TROTON 10265 stone chip protection UBS (white) 1000 g Anti-gravel

Surface preparation

• Polyester laminates should be degreased, dry sanded (P80-P120) and degreased again.
• Polyester putties should be dry sanded (P120).
• Primers should be degreased, dry sanded (P220-P280) and degreased again.
• Steel surfaces should be degreased, dry sanded (P80-P120) and degreased again.
• Stainless steel should be degreased.
• Aluminium and zinc surfaces should be degreased, dulled with the abrasive cloth and degreased again.
• Old coatings should be degreased, dry sanded (P220-P280) and degreased again.
• Plastic surfaces should be washed with detergent, dulled with abrasive cloth and degreased.

Use

Shake before use!

Apply 2 or 3 layers with interval of 5-10 minutes between each layer.
If applied directly on steel, it is recommended to apply top coat or enamel first.

Spray gun parameters

Pressure : 4-5 bar

Layer thickness

The recommended dry thickness is between 350 and 400 μm (500 – 550 μm wet)

Drying time

40 ÷ 60 minutes at 20°C

Over Coating

Clear coat can be applied 1 hour after the last layer has been applied.

Caution: To maintain safety, always follow the instructions given in the Safety Data Sheet for the product.