ABRO 13-AB SILICONE GASKET MAKER Clear 85g

MAKES ALMOST ANY GASKET INSTANTLY.
Replaces most cut gaskets. Forms to any shape instantly; cures fast. Resists cracking, shrinking and migration caused by thermal cycling.

Also seals timing chain covers and differential covers. Dries tough yet flexible.

Works up to 500°F (260°C). Resists oil, water, anti-freeze, and transmission fluid.

DIRECTIONS:
1.Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove all oil and grease.

2. Remove cap, puncture inner seal, screw on nozzle and cut to desired size.

3. Apply continuous, uniform 1/16' to 1/8' (1.5 mm to 3 mm) bead around perimeter of one surface. Completely surround all bolt holes.

4. Wait 10 minutes for silicone to "skin over". Reassemble parts.

NOTE: Leave thickness for gasket when reassembling. Do not over-tighten bolts.
Remove excess silicone with dry cloth or alcohol wipe. Silicone dries to touch in 1 hour.
Allow 24 hours to fully cure and bond. Replace cap after use.

CAUTION: ON CONTACT UNCURED SEALANT CAUSES IRRITATION.
Avoid contact with eyes and skin. IN CASE OF CONTACT, flush eyes with water. Call a physician.

Remove from skin with a dry cloth or paper towel.
Sealant releases acetic acid (vinegar-like odour) during curing, Use with adequate ventilation.

KEEP OUT OF THE REACH OF CHILDREN.

85g.